Samsung CA2-6BM Ultrasound Probe Repair

Before writing off a damaged Samsung CA2-6BM, compare its symptoms against the failure modes below. Many lens, cable and connector faults on this probe class are economically repairable.

Manufacturer	Samsung
Model	CA2-6BM
Probe type	Convex array
Compatible systems	Samsung HS50

In service the CA2-6BM is most often found on Samsung HS50. Console-side settings and module revisions still vary, so the exact system build is part of any assessment.

Curved arrays like the CA2-6BM see heavy abdominal duty, and the curved lens face takes the brunt of it – delamination and membrane wear typically show up before element failures do.

Common failure modes for the CA2-6BM

Match what you are seeing against the table below. The right-hand column reflects how faults of this kind typically assess – the actual verdict always depends on the individual probe.

What you see	Likely cause	Typically repairable?
Intermittent signal that changes as the cable moves	Broken internal conductors in the cable	Case by case
Noticeably weaker penetration than the paired probe	Reduced acoustic output from element ageing or a delaminating lens	Case by case
Connector lock broken or hardware missing	Broken locking mechanics on the connector housing	Usually repairable
Bent, broken or corroded connector pins	Connector damage from forced insertion or drops	Usually repairable
Split seams or impact marks on the probe body	Impact damage; housing can usually be replaced or resealed	Usually repairable
Strain relief pulling away from the cable or gone rigid	Flex fatigue where the cable meets the probe or connector	Usually repairable
Air pockets or peeling visible on the acoustic lens	Lens delamination from the acoustic stack	Usually repairable

Check these before you ship the probe

• Compare penetration and uniformity against a known-good probe on the same preset.
• Flex the cable gently along its length while imaging – intermittent dropout points to broken conductors.
• Examine the connector for bent or corroded pins, cracks and a working locking mechanism.
• Inspect the lens face under good light for cuts, bubbles, lifting edges or discoloration.
• Photograph the complete manufacturer label – the exact revision matters for parts compatibility.

Repair, exchange or replace — which applies to your CA2-6BM

Three paths apply to a failing CA2-6BM: repair (typical for lens, housing, cable and connector damage), exchange (fastest route back to scanning) or replacement (when the acoustic stack is too far gone). The deciding factors are how much of the array still fires, whether the housing is intact and what downtime costs you. Each probe is judged on its actual condition.

What we need to quote your CA2-6BM repair

• A clear photo of the complete manufacturer and model label on the probe
• A description of the fault: what you see on screen and when it started
• The ultrasound system (console) the probe is used with
• Screenshots or photos of the image problem, if the fault is visual
• Photos of any physical damage – lens, housing, cable or connector

Images shown are representative and are not photographs of an individual unit. Nothing on this page claims OEM authorization or guarantees universal fit. Whether a specific CA2-6BM can be repaired, and on what terms, is confirmed in writing once the probe has been assessed.