Toshiba PLU-1005BT (14L5) Ultrasound Probe Repair

The Toshiba PLU-1005BT (14L5) is a common candidate for repair rather than replacement. This page lists its typical failure modes, self-checks you can run, and the details a repair lab needs from you.

Manufacturer	Toshiba
Model	PLU-1005BT (14L5)
Probe type	Linear array
Compatible systems	Canon Xario 100 (TUS-X100), Canon Xario 100G (TUS-X100G), Canon Xario 100S (TUS-X100S), Canon Xario 200G (CUS-X200G)

In service the PLU-1005BT (14L5) is most often found on Canon Xario 100 (TUS-X100), Canon Xario 100G (TUS-X100G), Canon Xario 100S (TUS-X100S), Canon Xario 200G (CUS-X200G). Console-side settings and module revisions still vary, so the exact system build is part of any assessment.

Linear arrays like the PLU-1005BT (14L5) concentrate wear at the lens edges and the cable exit – shallow, high-frequency work means constant handling, and the first faults are usually mechanical rather than acoustic.

Common failure modes for the PLU-1005BT (14L5)

Match what you are seeing against the table below. The right-hand column reflects how faults of this kind typically assess – the actual verdict always depends on the individual probe.

What you see	Likely cause	Typically repairable?
Grainy, low-detail image even after presets are checked	Lens wear or early element degradation	Case by case
Connector lock broken or hardware missing	Broken locking mechanics on the connector housing	Usually repairable
Intermittent signal that changes as the cable moves	Broken internal conductors in the cable	Case by case
Strain relief pulling away from the cable or gone rigid	Flex fatigue where the cable meets the probe or connector	Usually repairable
Outer cable sheath showing cracks, kinks or staining	Jacket wear; conductors may still be intact underneath	Usually repairable
Pin damage or corrosion visible in the connector	Mechanical damage from forcing or dropping the connector	Usually repairable
Vertical shadowing or missing scan lines on screen	Element dropout, or a conductor break inside the cable	Case by case

Check these before you ship the probe

• Inspect the lens face under good light for cuts, bubbles, lifting edges or discoloration.
• Check the strain reliefs at both ends for splits, stiffness or separation from the cable.
• Flex the cable gently along its length while imaging – intermittent dropout points to broken conductors.
• Compare penetration and uniformity against a known-good probe on the same preset.
• Photograph the complete manufacturer label – the exact revision matters for parts compatibility.

Repair, exchange or replace — which applies to your PLU-1005BT (14L5)

Repair suits the PLU-1005BT (14L5) when damage is mechanical or confined – lens membrane, strain relief, cable jacket, connector hardware. Once element dropout spreads across large sections of the array, repair cost climbs toward replacement value and stops making sense. If uptime is critical, ask about exchange options while your probe is assessed.

What we need to quote your PLU-1005BT (14L5) repair

• A clear photo of the complete manufacturer and model label on the probe
• A description of the fault: what you see on screen and when it started
• The ultrasound system (console) the probe is used with
• Screenshots or photos of the image problem, if the fault is visual
• Photos of any physical damage – lens, housing, cable or connector

Product imagery on this page is representative of the PLU-1005BT (14L5) probe family and is not a photograph of your specific unit. This page does not claim OEM authorization or universal compatibility. Repair feasibility, turnaround and commercial terms are confirmed in writing after assessment of the actual probe.